Simulation of Evaporation and Condensation Phenomena in the Plate-Fin Converter of the LNG Process Using the CFD Method and Assessing Aspen Muse Software Performance

Document Type : Review Paper

Authors
Mohammad Irani 1
Reza Hayati 2
Mehran Sarmad 3
Peiman Moeen 4
1 Gas Division, Research Institute of Petroleum Industries (RIPI), Postal Code: 1485613111, Tehran, Iran
2 Process Development and Control Group, Process and Equipment Technology Development Division, Research institute of Petroleum Industry (RIPI), Tehran, Iran
3 Research and Technology Department, National Iranian Gas Company, Tehran, Iran
4 Gas Division, Research Institute of Petroleum Industries (RIPI), Postal Code: 137-14665, Tehran, Iran
Abstract
In this paper complex fluid flow and transport phenomena in plate-fin heat exchanger for LNG process are investigated. Modeling and simulation of heat transfer and fluid flow has been done using ANSYS Fluent software. This software has limitation in simulation of multispecies biphasic flow; therefore, UDF.A 2D model was used for modeling aforementioned phenomena in one channel of heat exchanger. HYSYS software was used for calculation of species equilibrium concentration and it was linked to ANSYS using UDF. Results shows that vapor volume fraction, species composition and heat transfer coefficient for CFD and Aspen muse are in good agreement, but pressure drop is over predicted by Aspen Muse. Using the developed model, a good deal of information was obtained about transport phenomena and fluid flow in cryogenic heat exchangers, while other software packages could not provide that much information.
Keywords
LNG
Plate-fin heat exchanger
CFD
Aspen muse
Subjects
  1. Thulukkanam, K., Heat Exchanger Design Handbook, 2nd Edition, CRC Press, 2013.
  2. Zohuri, B., Compact Heat Exchangers: Selection, Application, Design and Evaluation, Springer, 2016.
  3. Hesselgreaves, J.E., Compact Heat Exchangers: Selection, Design and Operation, Elsevier science Ltd, 2001.
  4. Guo, K., “Optimization of Plate/Plate-Fin Heat Exchanger Design”, PhD Thesis, School of Chemical Engineering and Analytical Science, Manchester University, 2015.
  5. Aluminium Plate-Fin Heat Exchangers, Linde Group.
  6. Kakac, S., M.R., Avelino, H.F., Smirnov, Low Temperature and Cryogenic Refrigeration, springer, 2003.
  7. Mudgala, S., “Numerical Analysis of Plate Fin Heat Exchanger at Cryogenic Conditions”, MS Thesis, Department of Mechanical Engineering National Institute of Technology Rourkela, 2015.
  8. Alur, S., “Experimental Studies on Plate Fin Heat Exchangers”, PhD Thesis, Mechanical Engineering Department National Institute of Technology Rourkela, 2012.
  9. Dewatwal, J., “Design of compact plate fin heat exchanger”, BS Thesis, Department of Mechanical Engineering National Institute of Technology Rourkela, 2009.
  10. Pandey, A., “Performance Analysis of a Compact Heat Exchanger”, MS Thesis, Department of Mechanical Engineering National Institute of Technology Rourkela, 2011.

  • Receive Date 25 April 2022